Instruction Manual

1. Overview of components
1−22
Festo P.BE−CPX−SYS−EN en 0902e
Interlinking blocks
Push pull
Description
Type CPX−M−GE−EV−S−PP−5POL
Interlinking blocks with push−pull system supply, of which precisely one of
each must be available for each CPX terminal.
 Operating voltage for internal electronics and for the internal electronics
of the CP modules connected to the CPX−CP interface
 Sensor supply for internal input modules and for the CP input modules
connected to the CPX−CP interface
 Load voltage supply for internal output modules and valves
 Load voltage supply for the CP modules connected to the CPX−CP inter
face
Type CPX−M−GE−EV−S−PP−5POL
1)
Interlinking blocks with push−pull forwarding function for supplying power
to subsequent equipment
 Must be placed immediately to the right of the system power supply.
 Only one interlinking block with forwarding function may be used for
each CPX terminal and
 The forwarding function must not be combined with additional power
supplies.
 Interlinking blocks with a push−pull forwarding function are identically
constructed to those with with a push−pull system power supply. It is
therefore necessary to provide external protection in both cases (see
section3.1.4)
Type CPX−M−GE−EV−Z−PP−5POL
1)
Interlinking blocks in metal version with push−pull additional power supply
for electrical outputs
 Must be placed to the right of the system power supply.
 The additional power supply must not be combined with the forwarding
function.
 Load voltage supply for the output module fitted and for the subsequent
output modules fitted to the right.
1) Optional − depends on the current consumption of the CPX modules and the connected compo
nents.
Tab.1/6: Interlinking blocks with supply (push−pull)