Instruction Manual

B. Parameters and data of the CPX terminal

B−6

Festo P.BE−CPX−SYS−EN en 0902e

Function no.

SeeCPX data and CPX parameters

3482 Number of entries in the diagnostic memory (diagnostic memory

data)

Tab.B/34

3483 Overrun (diagnostic memory data) Tab.B/35

3483 Status (diagnostic memory data) Tab.B/36

3484 Run/stop filter 2 (diagnostic memory parameters) Tab.B/26

3484 Fault end filter (diagnostic memory parameters) Tab.B/27

3484 Error number filter (diagnostic memory parameters) Tab.B/28

3484 Module/channel filter (diagnostic memory parameters) Tab.B/29

3485 Module number MN (diagnostic memory parameters) Tab.B/30

3486 Channel number KN (diagnostic memory parameters) Tab.B/31

3487 Error number FN (diagnostic memory parameters) Tab.B/32

3488 + n Diagnostic memory data (diagnostic memory data) Tab.B/37

4401 Monitoring (system parameters) Tab.B/4

4402 Fail safe (system parameters) Tab.B/5

4402 Force mode (system parameters) Tab.B/6

4402 System idle mode (system parameters) Tab.B/7

4402 System start (system parameters) Tab.B/8

4402 Analogue process value display (data format) Tab.B/9

4828 + m * 64 + 0 Monitoring the CPX module (module parameter) Tab.B/12

4828 + m * 64 + 1 Behaviour after short circuit/overload (module parameter) Tab.B/13

4828 + m * 64 + 1 Input debouncing time (module parameters) Tab.B/14

4828 + m * 64 + 1 Signal extension time (module parameters) Tab.B/15

4828 + m * 64 + 3 Data format for analogue value of inputs (module parameters) Tab.B/16

4828 + m * 64 + 3 Data format for analogue value of outputs (module parameters) Tab.B/17

1) m = module number (counting on the modules from left to right, beginning with 0)