Instruction Manual

5. Diagnostics and error handling
5−29
Festo P.BE−CPX−SYS−EN en 0902e
Error numbers of error class 1
No. Handheld texts Operating status Eliminating faults
200 [Fault param. transfer mo
dule n]
Fault in parametrisation
(parameter transfer failed)
Replace module if Power Off/
On does not remedy problem
201 [Invalid field bus address] Address incorrect Check the DIL switch setting,
correct if necessary
202 [Protokoll Asic not ready] Initialisation of the Chips
protocol defective
Replace module if Power Off/
On does not remedy problem
203 [MMI serves CPX module] MMI serves CPX modules,
parametrisation is not possi
ble via the fieldbus node or
FEC
Terminate MMI access
204 [Invalid setting switch unit] Invalid switch setting Check the DIL switch setting,
correct if necessary
205
...
254
Reserved
255 [unknown fault]
Tab.5/10: Possible faults (fault class 1)