Instruction Manual

4. Commissioning
4−8
Festo P.BE−CPX−SYS−EN en 0902e
Channel−specific parameters Brief description
Signal extension Serves for recognising short signals
Monitoring of wire break Serves for recognising connection faults
Fault mode Defines the status that the relevant channel is to assume in
the event of fieldbus communication faults
Fault state
the event of fieldbus communication faults.
Idle mode Defines the status which digital output signals (outputs and
valves) are to assume when the Idle function is accessed. This
Idle state
valves)
are
to
assume
when
the
Idle
function
is
accessed
.
This
function is only relevant with certain fieldbus protocols (see
manual for specific CPX bus node).
Force mode Actual signals are replaced in the processing image by the force
settings
Force state
settings.
Tab.4/4: Module parameters  part 2
Detailed information on the parameters, which are supported
by the module you are using used, can be found in the man
ual for the relevant module. Basic principles of using the
parameters can be found in Appendix C.
Diagnostic memory parame
ters
Brief description
Entries, remanent Determines whether the contents of the diagnostic memory are
to be retained after new Power on or whether they are to be de
leted.
Diagnostic memory filters
 Run/stop filter 1 + 2
 Fault end filter
 Fault number filter
 Module/channel filter
With the diagnostic memory filters you can suppress the regis
tering of certain error messages and control both the star ting
and stopping of the fault registering.
Tab.4/5: Diagnostic memory parameters