User guide

C. Configuration with CPX node
C−7
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Note
CPX terminals with the CMAX always require new parame
trisation and commissioning after exchanging the CPX ter
minal or the CMAX, since the parameters and the data as
certained during commissioning are only stored in the
CMAX, see section 1.1.2.
The CMAX cannot be parametrised via the start−up parame
trisation. This must always
be done via the FCT or via the
special parametrisation function.
Fig.C/3: No specific parameters