User guide

5. Parameter
5−57
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
FHPP: Control/Status bits: CPOS.HALT support
(FHPP: Control/Status bits: CPOS.HALT support)
PNU PNU: 522 Index: 1 Max index: 2 Class: Struct Data type: int32
Values Without unit
Default: 0 Minimum: 0 Maximum: 1
Configuration of the intermediate stop (CPOS.HALT, reserved for future extensions).
Value Function
0 Intermediate stop status is not supported.
1 Reserved
o The parameter value cannot be changed.
ý Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.
FHPP: Control/Status bits: CCON.BRAKE level
(FHPP: Control/Status bits: CCON.BRAKE level)
PNU PNU: 522 Index: 2 Max index: 2 Class: Struct Data type: int32
Values Without unit
Default: 0 Minimum: 0 Maximum: 1
Effect of clamping unit/brake.
Value Function
0 Brake opens (switching output on valve at 24V) with CCON.BRAKE = 1
1 Brake opens (switching output on valve at 24V) with CCON.BRAKE = 0
o The parameter value cannot be changed.
ý Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.