Specification

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission Regulation (EU) 2015/830 - United Kingdom (UK)
Cleaner F3 500ml
5/11
SECTION 7: Handling and storage
Store between the following temperatures: 0 to 30°C (32 to 86°F). Store in accordance with local regulations. Store
in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible
materials (see Section 10) and food and drink. Keep container tightly closed and sealed until ready for use.
Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Do not store in
unlabelled containers. Use appropriate containment to avoid environmental contamination.
7.3 Specific end use(s)
Consumer applications, Professional applications.
Water-boiler treatment.
Recommended monitoring
procedures
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness
of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to monitoring standards, such as
the following: European Standard EN 689 (Workplace atmospheres - Guidance for
the assessment of exposure by inhalation to chemical agents for comparison with
limit values and measurement strategy) European Standard EN 14042 (Workplace
atmospheres - Guide for the application and use of procedures for the assessment
of exposure to chemical and biological agents) European Standard EN 482
(Workplace atmospheres - General requirements for the performance of procedures
for the measurement of chemical agents) Reference to national guidance
documents for methods for the determination of hazardous substances will also be
required.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn,
unless the assessment indicates a higher degree of protection: safety glasses with
side-shields.
Eye/face protection
:
:
Skin protection
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products,
before eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and
safety showers are close to the workstation location.
8.2 Exposure controls
Hygiene measures
:
No DNELs/DMELs available.
PNECs
No PNECs available
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
DNELs/DMELs
Individual protection measures
The information in this section contains generic advice and guidance. Information is provided based on typical
anticipated uses of the product. Additional measures might be required for bulk handling or other uses that could
significantly increase worker exposure or environmental releases.
Occupational exposure limits
Product/ingredient name
Exposure limit values
propane-1,2-diol
EH40/2005 WELs (United Kingdom (UK), 12/2011).
TWA: 10 mg/m³ 8 hours. Form: Particulate
TWA: 474 mg/m³ 8 hours. Form: Sum of vapour and particulates
TWA: 150 ppm 8 hours. Form: Sum of vapour and particulates
Date of issue/Date of revision
:
04/02/2020
Version
:
3.2
No previous validation
:
Date of previous issue