Assembly Instructions

www.fernco.com
FLEXIBLE COUPLINGS
21
United States
PH: 810-653-9626
FX: 810-653-8714
Canada
PH: 519-332-6711
FX: 519-332-8610
07/08
Expansion Joints
One piece design for trouble-free vertical pipe installations.
Fernco’s one-piece expansion joints allow for thermal expansion and contraction of drain,
waste and vent pipes and inside rain water conductor systems. They eliminate costly
osets normally used to accommodate expansion and contraction.
Fernco Expansion Joints will accommodate a maximum of 1-1/2"
expansion and 1/2" contraction from a normal position. For A.B.S.
pipe use 2 x value of Column 1 and 1/2 x value of Column 2.
Column 1 Column 2
Temp. Expansion Limit Per
Change Per Ft. Expansion
Degrees F (Inches/mm) Joint (Ft.)
50° ................0174 (.0442cm) ............... 86
60° ................0209 (.0351cm) ............... 71
70° ................0244 (.0620cm) ............... 61
80° ................0278 (.0760cm) ............... 54
100° ...............0348 (.0884cm) ............... 43
Thermal Expansion Table for P.V.C. Pipe
• Unique one-piece construction
• Internal stops of positive positioning
• No sliding parts to malfunction
• No packing to jam, freeze or leak
• Maintenance-free
Part No. Nominal Pipe Size
XJ-150 1-1/2" (38mm)
XJ-2 2" (50mm)
XJ-3 3" (76mm)
XJ-4 4" (101mm)
XJ TECHNICAL SPECS
Pipe Sleeve Seals
To seal pipe sleeves and carrier pipes.
• Positive, mechanical seal around
pipe sleeves and copper or plastic
carrier pipe
• Use above or below ground
• No mastics or other sealing
compounds needed
• 300 series stainless steel clamps
Pipe-Sleeve Seals provide positive, mechanical seals around pipe sleeves and copper or
plastic carrier pipe, above or below ground, to keep out dirt, water, and insects.
Carrier pipe slides easily through the Fernco pipe sleeve seal, for fast, convenient
installation. Two all-stainless steel clamps tighten easily with a screw driver. No need
for mastics or other sealing compounds that can damage plastic pipes.
Part No. Pipe Sleeve Size Carrier Pipe Size
DTC 110 1-1/2" 3/4 or 1"
DTC 210 2" 3/4 or 1"
1056-315 3" 1-1/2"
1056-32 3" 2"
1056-415 4" 1-1/2"
1056-42 4" 2"
1056-43 4" 3"
TECHNICAL SPECS