Installation Instructions

7
United States
PH: 810-653-9626
FX: 810-653-8714
Canada
PH: 519-332-6711
FX: 519-332-8610
www.fernco.com
07/08
1. 2. 3. 4. 5.
6. 7. 8. 9. 10.
11. 12. 13.
Core a perpendicular
hole to the main line:
- 5” hole for 4” pipe inlet
- 7” hole for 6” pipe inlet
- 9” hole for 8” pipe inlet
Using sand paper or a
le, clean and remove
any burrs from opening.
Remove band clamp
from QwikSeal, fold and
insert into opening.
Unfold.
Pull up on QwikSeal
until it stops against
the inside of the pipe.
Measure the depth of
the QwikSeal, from the
pipe stop to the top
edge.
Add the dimensions of
the QwikSeal and the
tting and cut a stub
to that length.
Lubricate the QwikSeal
and pipe stub.
Start the pipe stub into
the QwikSeal by hand.
Using a hammer and
block of wood, drive
the pipe stub to the
QwikSeal pipe stop.
Install the band clamp
at 60” lbs. torque.
Installation Instructions
Measure the depth
of the tting to be
attached to the pipe
stub.
See alternative
method below.
Bevel the leading edge
of the pipe stub for
easier insertion into
the QwikSeal.
Install pipe tting.
Fitting should sit ush
with the surface of the
QwikSeal.
Fitting and QwikSeal should be ush.
Alternative method to stub and tting:
You may also use the bell end of a piece of SDR-35 or SCH-40 instead of the
stub and tting method. After measuring the depth of the QwikSeal in step
5, transfer this measurement to the bell end of your inlet pipe, measuring
from the bell. (See gure A) Proceed with steps 8 - 12.
A. B.
Connect lateral pipe and check for leaks prior to backlling.
HOT PRODUCTS