Assembly Instructions

1. Apply Epoxy Putty 2. Immerse Wrap in Water
3. Wrap Pipe 4. Tighten for Approx 4 Min
Fernco, Inc. • Davison, MI Fernco Connectors, LTD • Sarnia, Ontario Fernco, Inc. West • Sparks, NV
1-800-521-1283 • FAX: [phone] • FAX: [phone] • FAX: [phone]
PART # DESCRIPTION
FPW248CS 2” x 48” wrap to repair up to 1” diameter pipe
FPW3132CS 3” x 132” wrap to repair 1¼” to 3” diameter pipe
FPW4252CS 4” x 252” wrap to repair 3” to 6” diameter pipe
NEW
NO TOOLS EPA ANSI/ CURES IN STRONG!
NEEDED! APPROVED! NSF 61 30 MIN! 600 PSI
Perfect for repairing:
• Copper • Rubber • Concrete
• Plastics • Fiberglass • And MORE!
• PVC Pipe • Galvanized
Ideal for all fluid bearing pipes and hoses:
• Water • Sewage • Air
• Steam • Fuel • Hydraulics
Recommended for structural repairs to:
• Brackets • Mufflers • Fencing
• Supports • Exhaust Pipes • Tools
EACH KIT CONTAINS:
• Resin impregnated fiberglass tape in foil bag
• Epoxy putty to enhance repairs
• 1 pair of protective gloves
• Complete installation instructions
Pow-R Wrap is a strong, permanent and economical repair.
Works on virtually every kind of pipe. An easy alternative to
traditional methods such as cementing, soldering, welding,
sleeving and replacement. Works on wet, dry, clean, dirty or
corroded pipes. Even works under water...salt or fresh.
TECHNICAL INFORMATION
Form ..........................................Impregnated Fiberglass Cloth
Color..........................................Grey
Fabrication Method .....................Wet Lay-Up
Number of Wraps Required .........8 Minimum for High Pressure
Cure Cycle @ 70ºF/21ºC .............30 Minutes (wet)
Hardness - Cured Laminate ..........53 Barcol
Heat Resistance ...........................
1197ºF/647ºC
Dielectric Strength .......................
16,969
Line Pressures ..............................
600PSI/40KPA
Shelf Life .....................................Unlimited when properly stored
MECHANICAL RESISTANCE
MEASURE METHOD PSI KPA
Flexural Strength .............ASDN D 709-71 .....
16,100 ...... 1,073
Tensile Strength ...............ASTM D 638 ...........
24,000 ...... 1,660
Compression Strength ......ASTM D 695-77 ......
26,600 ...... 1,773
Temperature Cycle Test .....4 layers cycled from 50ºF to 90ºF
(10ºC to 33ºC): No Delamination
APPROVED TO EPA601
Tested and approved for use with potable (drinking) water when
used in accordance with instructions. Also approved to other
international standards including AS4020.
TOXICITY
Contains no harmful solvents. Can be used on water and food
service lines.
CHEMICAL RESISTANCE
Pow-R Wrap is chemically resistant to diesel fuel, petroleum
products, halocarbon, and (after curing) alcohols.
3 KIT SIZES AVAILABLE FOR REPAIRING UP TO 6” DIA. PIPES
FAST
AND
EASY
TO
INSTALL