Installation Instructions

August 8,
2008
Check Valves
for sump pumps.
Installation Instructions:
PLEASE NOTE: This is a one way valve and
needs to be installed top end up.
1. Threaded Model - Thread check valve into
pump discharge, connect corrugated sump pump
hose kit or any type of existing pipe by clamping
the coupling over the pipe and the top side of the
check valve. Tighten with hose clamps.
2. Basic Model - Install top up on the riser pipe.
With two couplings, and four hose clamps,
assemble using one coupling and two hose
clamps on each end.
Part No. Description
CV-125T 1¼" MPT x 1½" or 1¼"
CV-150T 1½" MPT x 1½" or 1¼"
CV-150 1½" or 1¼" x 1½" or 1¼"
CV-200 2" x 2"
10:15:44
AM
Page 1 of 2Fernco, Inc.
8/8/2008htt
p
://www.fernco.com/CV.as
p