Operation Manual

Ferm 7

Mains connection

Only use earthed sockets with earthing wire connected per the regulations.

Replacing the mains connection cable

The mains connection cable may only be replaced by a special cable in a specialised workshop.

Replacing cables or plugs

Dispose of old cables or plugs immediately after replacing them. It is dangerous to connect the plug of a

loose cable to a wall socket.

Using extension cables

Only use an approved extension cable, corresponding to the machine power use. The wires must have

a minimum cross section of 1.5 mm

. If the cable is on a reel, it must be fully paid out.

3. INSTALLING ACCESSORIES

Always disconnect the machine from the main power supply before carrying out any

maintenance work

Installing the protective cover

Fig.B

• Beforecommissioningthemachine,theprotectivecover(5)mustbeinstalled.

• Insertthescrewfromtheinsideleft,thenaffixthewasherandthesafetyringfromtherightside.The

safety ring (A) may be left out optionally.

• Screwtheknurlednutintight.

Installing the cross guide

Fig.C

The cross guide (3) allows material to be bevelled, and can be simultaneously used to support the

material as it is fed through the saw.

Mounting the rubber feet

Fig. G

The enclosed rubber feet contribute to a steady position of the scroll saw on your worktable

• Placetherubberfootonitsplace

• Connecttherubberfootwithhelpoftheenclosedbolt,ringandnut

• Tightenthenutwithawrench

Sawdust blower

Fig. H

The sawdust blower keeps the workpiece clean for more accurate scroll cuts. For best results, always

direct air flow from the blower tube at blade and workpiece. To adjust, simply bend to desired position.

Installation

• Placethesawdustblowerontheholeontopofthemachine

• Turntheblowpipeclockwiseintothehole