User manual

5
EN
● Neverputthemachinedownonatableor
a workbench before it has been switched off.

3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Donotusethemachineifthemainscableor
the mains plug is damaged.
● Onlyuseextensioncablesthataresuitablefor
the power rating of the machine with
a minimum thickness of 1.5 mm
2
.Ifyouuse
a extension cable reel, always fully unroll the
cable.

Ifthemoulded3-pinplugattachedtotheunitis
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approvedBS1363/5Afusedplugandthatthe
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- Thewirewhichiscolouredbluemustbe
connected to the terminal which is marked with
the letter N or coloured black.
- Thewirewhichiscolouredbrownmustbe
connected to the terminal which is marked with
theletterLorcolouredred.
TECHNICAL DATA
PDM1027
Mainsvoltage V~ 230
Mainsfrequency Hz 50
Powerinput W 710
No-loadspeed min
-1
 0-2,700
Impactrate min
-1
 0-43,200
Max. drill bit diameter
Wood mm 25
 Concrete mm 13
 Steel mm 10
Protectionclass  IP20
Weight kg 1.9
NOISE AND VIBRATION
PDM1027
Soundpressure(L
pa
) dB(A) 91
Acousticpower(L
wa
) dB(A) 102
Uncertainty(K) dB(A) 3
Vibration
 Metal m/s
2
14.27
 Concrete m/s
2
 3.50
Uncertainty(K) m/s
2
1.5
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardisedtestgiveninEN60745;itmaybeused
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- usingthetoolfordifferentapplications,orwith
different or poorly maintainted accessories,
maysignicantlyincreasetheexposurelevel
- thetimeswhenthetoolisswitchedofforwhen
it is running but not actually doing the job, may
signicantlyreducetheexposurelevel
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
yourhandswarm,andorganizingyourwork
patterns

Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
 1. On/offswitch
 2. Lock-onbutton
 3. Speedadjustmentwheel
 4. Forward/reverseswitch
 5. Switchfordrilling/hammerdrilling
 6. Chuck
7. Main grip
8. Auxiliary grip
 9. Depthstop
10. Storagesystem(drillbits)