User manual

7
EN
ASSEMBLY
3
Before assembly, always switch off the
machine and remove the mains plug
from the mains.

Refer to the table below to select the required
saw blade.
Saw blade Material
Coarse Wood
Medium Wood
Fine Steel,aluminium,plastic
Veryne Wood(curves)
2
Do not attempt to remove the guard from
the machine.
Mounting
● SlackentheAllenscrew(13)usingtheAllen
key(11).
● Insertthesawblade(14)inthesawblade
holder(6)asfaraspossible.Theteethofthe
sawblade(14)mustpointupwardand
forward. The smooth side of the saw blade
mustengageintheslotoftheguideroller(15).
● TightentheAllenscrew(13)usingtheAllen
key(11).
Removing
● SlackentheAllenscrew(13)usingtheAllen
key(11).
● Removethesawblade(14)fromthesaw
bladeholder(6).
● TightentheAllenscrew(13)usingtheAllen
key(11).
Mounting and removing the parallel guide

The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
● Slackenthelockingbolts(8).
● Inserttheparallelguide(16)intothesawshoe
(7).
● Settheparallelguide(16)totherequired
position.
● Tightenthelockingbolts(8).
Removing
● Slackenthelockingbolts(8).
● Removetheparallelguide(16)fromthesaw
shoe(7).
● Tightenthelockingbolts(8).
USE

● Toswitchonthemachine,presstheon/off
switch(1).
● Toswitchthemachinetocontinuousmode,
keeptheon/offswitch(1)pressedand
simultaneouslypressthelock-onbutton(2).
● Toswitchoffthemachine,releasetheon/off
switch(1).

The speed adjustment wheel is used for setting
the sawing speed. The speed adjustment wheel
can be set to 6 positions. The ideal sawing speed
dependsontheproleandtheteethofthesaw
blade and on the material to be worked.
2
Do not set the sawing speed during use.
● Turnthespeedadjustmentwheel(3)tothe
required position.
● Forhardmaterials,useasawbladewithne
teeth and select a lower speed.
● Forsoftmaterials,useasawbladewith
coarse teeth and select a higher speed.

Themitreangleisvariablebetween0°and45°.
2
Do not set the mitre angle during use.
● SlackentheAllenscrews(17)usingtheAllen
key(11).
● Tiltthesawshoe(7)totherequiredposition.
● TightentheAllenscrews(17)usingtheAllen
key(11).

The pendulum action switch is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions.
2
Do not set the pendulum position during
use.
● Turnthependulumactionswitch(4)to
required position according to the material to
be worked. Refer to the table below to select
the required position.