User manual

8
EN
accessories must be inserted.
● Regularlycheckthegreaselevelinsidethe
machine:
- Remove the cover from the lubrication point
(9)usingascrewdriver.
- Remove the cap from the lubrication point
(9).
- Ifnecessary,addsomegreaseintothe
lubricationpoint(9).
- Mountthecaptothelubricationpoint(9).
- Mountthecovertothelubricationpoint(9)
using a screwdriver.
Checking and replacing the carbon brushes

The carbon brushes must be checked regularly.
Ifthecarbonbrushesareworn,themachinewill
start to run unevenly.
2
Only use the correct type of carbon
brushes.
● Removethecarbonbrushholders(10)using
a screwdriver.
● Cleanthecarbonbrushes.
● Incaseofwear,replacebothcarbonbrushes
at the same time.
● Mountthecarbonbrushholders(10)using
a screwdriver.
● Aftermountingthenewcarbonbrushes,letthe
machine run at no load for 15 minutes.
WARRANTY
Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.

Donotdisposeofpowertoolsintodomestic
waste. According to the European Guideline
2002/96/ECforWasteElectricalandElectronic
Equipmentanditsimplementationintonational
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change.Specicationscanbechangedwithout
further notice.