User manual

7
EN
● Releasethelockingsleeve(5).

Mounting
● Loosentheauxiliarygrip(7)byturning
it counterclockwise.
● Mounttheauxiliarygrip(7)byslidingitover
the chuck (4).
● Turntheauxiliarygrip(7)totherequired
position.
● Tightentheauxiliarygrip(7)byturning
it clockwise.
Removing
● Loosentheauxiliarygrip(7)byturning
it counterclockwise.
● Removetheauxiliarygrip(7).
● Tightentheauxiliarygrip(7)byturning
it clockwise.

Mounting
● Loosentheauxiliarygrip(7)byturning
it counterclockwise.
● Insertthedepthstop(8)throughtheholein
theauxiliarygrip(7).
● Setthedepthstop(8)totherequiredposition.
● Tightentheauxiliarygrip(7)byturning
it clockwise.
Removing
● Loosentheauxiliarygrip(7)byturning
it counterclockwise.
● Removethedepthstop(8).
● Tightentheauxiliarygrip(7)byturning
it clockwise.
Mounting and removing the dust collector

The dust collector prevents dust from entering the
machine when drilling into ceilings.
2
Immediately replace a damaged dust
collector.
Mounting
● Ifnecessary,removetheaccessoryfromthe
chuck (4).
● Slidethedustcollector(15)overtheshaftof
the accessory.
● Inserttheaccessorywiththedustcollector
(15) into the chuck (4).
Removing
● Removetheaccessorywiththedustcollector
(15) from the chuck (4).
● Removethedustcollector(15)fromthe
accessory.
USE

● Toswitchonthemachine,presstheon/off
switch (1).
● Toswitchoffthemachine,releasetheon/off
switch (1).

The drill selection switch and the hammer
selection lever must be set according to the
requiredoperatingmode.Refertothetablebelow
tosettherequiredoperatingmode.
 
A Demolitionhammer/Chisel
B Hammerdrill
C Drill
● Turnthedrillselectionswitch(2)andthe
hammerselectionlever(3)totherequired
position.
Hints for optimum use
● Clamptheworkpiece.Useaclampingdevice
for small workpieces.
● Firmlyholdthemachinebythegrip.
● Settheoperatingmode.
● Switchonthemachine.
● Donotapplytoomuchpressureonthe
machine. Let the machine do the work.
● Switchoffthemachineandwaitforthemachine
to come to a complete standstill before putting
the machine down.
CLEANING AND MAINTENANCE
4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularlycleanthehousingwithasoftcloth.
● Keeptheventilationslotsfreefromdustand
dirt.Ifnecessary,useasoft,moistclothto
remove dust and dirt from the ventilation slots.

● Regularlygreasetheshaftinwhichthe