User manual

6
EN
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- Thewirewhichiscolouredbluemustbe
connected to the terminal which is marked with
the letter N or coloured black.
- Thewirewhichiscolouredbrownmustbe
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
HDM1014
Mainsvoltage V~ 230
Mainsfrequency Hz 50
Powerinput W 1,100
No-loadspeed min
-1
0-750
Impactrate min
-1
0-2,920
Max.drillingdiameter
 Wood mm 40
 Steel mm 16
 Concrete mm 30
Weight kg 6.25
NOISE AND VIBRATION
HDM1014
Hammerposition
Sound pressure (L
pa
) dB(A) 89
Acoustic power (L
wa
) dB(A) 106
Uncertainty(K) dB(A) 3
Vibration m/s
2
 6.89
Uncertainty(K) m/s
2
1.5
Hammer/drillposition
Sound pressure (L
pa
) dB(A) 93
Acoustic power (L
wa
) dB(A) 107
Uncertainty(K) dB(A) 3
Vibration m/s
2
 10.61
Uncertainty(K) m/s
2
1.5
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745;itmaybeusedtocompareonetoolwith
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- usingthetoolfordifferentapplications,orwith
different or poorly maintainted accessories,
maysignicantlyincreasetheexposurelevel
- thetimeswhenthetoolisswitchedofforwhen
it is running but not actually doing the job, may
signicantlyreducetheexposurelevel
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
yourhandswarm,andorganizingyourwork
patterns

Your hammer drill has been designed for drilling
holes into wood, steel, and masonry. The
machine can also be used as a demolition
hammerincombinationwiththeSDSchisels.
 1. On/offswitch
 2. Drillselectionswitch
 3. Hammerselectionlever
4. Chuck
5. Locking sleeve
 6. Maingrip
 7. Auxiliarygrip
 8. Depthstop
 9. Lubricationpoint
10. Carbonbrushholder
ASSEMBLY
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.


2
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
Mounting
● Applyafewdropsofoiltotheshaftofthe
accessory.
● Slidethelockingsleeve(5)totherear.
● Inserttheaccessoryintothechuck(4).
● Securetheaccessorybyturningit
counterclockwise until it locks into place.
● Releasethelockingsleeve(5).
Removing
● Slidethelockingsleeve(5)totherear.
● Removetheaccessoryfromthechuck(4).