Operation Manual

8
EN
Cleaning
Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth moistened with
soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Troubleshooting
Please nd some potential causes and solutions
to possible failure.
1 The operating switch is switched on, but
the motor is not working
• The electric circuit is broken
• Havetheelectriccircuitrepaired
• Wires in the mains plug or in the socket are
loose
• Havesocketandplugcheckedorrepaired
• The switch is faulty
• Havetheswitchrepaired
2 Router runs slowly
• Blunt or damaged cutter
• Re-sharpenorreplacecutter
• Variable speed set low
• Increasevariablespeed
• Motor is overloaded
• Reducepushingforceonrouter
3 Excessive vibration
• Bent cutter shank
• Replacecutter
4 Sparks inside the housing
• Carbon brushes are worn
• Replacethecarbonbrushes
Faults
Should a fault occur, e.g. after wear of a part,
please contact the adress on the warranty card.
Included you nd an exploded view showing the
parts that can be ordered.
Environment
In order to prevent the machine from damage
during transport, it is delivered in a sturdy
packaging. Most of the packaging materials can
be recycled. Take these materials to the
appropriate recycling locations.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Warranty
The guarantee conditions can be found on the
separately enclosed guarantee card.
The product and the user manual are subject to
change. Specications can be changed without
further notice.