Submittal Sheet

Effective: January 2014
6 F-01-020 Rev AA
(8) Moisture Resistant Seal
01-990080-001 (8A) Under certain conditions where
there is excessive moisture or vapor, a moisture
resistant seal may be added to protect the interior of
the THERMOSWITCH
®
controller. Modification 13
should be ordered with this modification.
01-990080-002 (8B) A same as 8A above except
seal is four hold type so dial and knob may be used.
Modification 13 should be ordered with this
modification.
(10) Moisture Resistant Tamper-proof Cap
01-99011X-XXX
To seal a controller against moisture and tampering,
a moisture resistant, tamper-proof cap may be
mounted over the adjusting sleeve. It may be used
with unset or factory preset units.
(13) Packing Gland and Lead Wires
01-990130-00X
In installations where moisture may enter
THERMOSWITCH
®
controller around lead wires, a
packing gland is recommended. Modification 8
should be used with this modification.
(14) Extended Temperature Adjusting Sleeve
01-990140-XXX
Adjustment sleeve extensions are available only in
multiples of one inch. Why ordering, the length
specified is the “extended by” length “L”. For
example, if the standard adjusting sleeve length for
the controller ordered is 3/8 to 5/8 inch, and a 4 inch
extension is ordered, the overall length will be 4-3/8
to 4-5/8 inches. Minimum ordering quantities apply.