Submittal Sheet

Effective: January 2014
F-01-020 Rev AA
5
MODIFICATIONS
(1) Special Marking
01-990010-XXX
Special marking may be rubber stamped in indelible
ink at points A, B, or C. Amount of marking is limited
to the space available.
Specify test and location of marking.
(2) Extended Lead Wires
01-9902X-XXX
Lead wires may be extended to any length. Wire
lengths are specified at that portion of lead wire
outside of the THERMOSWITCH
®
controller,
indicated by dimensions “L”. Special lead wire
stripping may also be obtained by specifying length
shown as dimension “X”.
(3) Factory Temperature Setting
01-990030-00X
The controller may be preset at Fenwal to any temperature within its listed range to a minimum of
32
º
F (0
º
C). Unless this modification is specified, units are preset at approximately 75
º
F (25
º
C).
Modification 4 is recommended when ordering a factory set unit to preclude a possible shift in set
point do to mishandling.
(4) Temperature Restraining Device
01-990040-000
A restraining device may be added to secure the
temperature adjustment sleeve after calibration.
This modification deters tampering with the setting.
It also minimizes the possibility of a shift in
calibration due to vibration.
(5) Tamper-proof Cap
01-990050-000
A tamper-proof cap can be furnished to prevent
tampering with a THERMOSWITCH
®
controller
equipped with Modification 4 above.