Specifications

 Quick-release bicycle mount, easy to assemble and disassemble.
 Reliable all-metal heat fin; IP67 rated protection.
 Compatible with Fenix bicycle light helmet holder, can be used on a helmet.
 Dual Distance Beam System.
Operating instruction
Bicycle light①
Switches
Functional switch
On/Off
Press and hold the functional switch for 0.5s to turn on/off the light.
Output Selection
With the light switched on, single click the functional switch to cycle through
EDC/Eco→Low→Med→High.
Flash
With the light switched on, double click the functional switch to enter flash mode; single click the
functional switch again to exit flash mode.
Wireless Remote Switch②
Switches
Output selection switch Burst
Connecting with BC30 V2.0
First Connection
Press and hold the functional switch for 5 seconds, and the switch will flash red and green
alternately, then single click any switch of the wireless switch, the bicycle light will light up to
indicate connection is completed.
Note: 1. After the first connection, the wireless remote switch automatically memorizes the
paired status. There is no need to match again afterwards.
2. The linear distance between the light and the wireless switch should not exceed 1.5 meters
during the pairing process.
Output Selection
With the light switched on, press and hold the output selection switch for 0.5s to enter/exit
standby status, single click to cycle through EDC/Eco→Low→Med→High. And the light will
automatically shut down after 10 minutes standing by if without any operation.
Instant Burst