User Manual

1) Place the unit against the selected mounting surface.

2) Mark the areas where the mounting holes will be drilled.

If the mounting surface is part of the vehicle, make sure

no vital components could be damaged by the drilling

process.

3) Drill two mounting holes in the marked surface as well

as a 0.5" diameter hole for wire passage (if mounting on a

vehicle). Use the rubber pad to position the 0.5" hole for

the wires. Make sure to deburr holes thoroughly. Use a

grommet if needed.

4) Pass the wires through the 0.5" diameter hole, and

secure the light head to the mounting surface with the

provided hardware.

MOUNTING INSTRUCTIONS

Screw

Rubber Pad

Wire Pass-through

FENIEX // 2018 // INSTRUCTION MANUAL // v2.0

WEB // www.feniexindustries.com