User Manual
WIRING DIAGRAM & CONFIGURATION INSTRUCTIONS
COLOR FUNCTION CONNECTION
Red
Battery / 12v (+) Positive Battery Terminal
Blue
Pattern / 12v (-) Momentary Switch
Black
Ground / 12v (-) Chasis Ground
WIRING DIAGRAM
Black Wire
Blue Wire
Red Wire
12v Battery
SETTING MASTER/SLAVE
1) Apply 12v (+) power and 12v (-) ground to the unit.
2) For the light heads to alternate, one light head must be
set as master and the other set as slave. To do so, hold the
blue (ash pattern changer) wire to ground for 3 seconds.
If all LEDS turn on, this indicates master mode. If no LEDs
activate, this indicates slave mode.
POWER
1) To power the unit, extend the red wire to a 12v (+) post.
Extend the black wire to the ground post of the vehicle's
battery.
PATTERNS & SYNCHRONIZATION
1) Momentarily tap the blue wire to a ground 12v (-) source
to cycle through the ash patterns.
2) Synchronization: To synchronize two or more T3 units
(or compatible products) together:
A) Choose the desired ash pattern for each unit.
B) Connect the blue wires of the light heads
together.
To achieve syncronization, the patterns must match on all
products connected to the synchornization circuit.
Each time the master/slave mode is set, the pattern will reset
to the default setting (Single Flash [Slow]). This simplies the
process of synchronizing two or more compatible products.
The T3 can be synchronized with other compatible products
with matching patterns (single color). Consult the instruction
manual of each product as the process may dier by model.
FENIEX // 2018 // INSTRUCTION MANUAL // v2.0
WEB // www.feniexindustries.com
5
TM