Service Manual

Cab Air Suspension
8-18 627333-A
CAB AIR SUSPENSION REMOVAL
FIG. 2: Tip over the cab.
IMPORTANT: Don’t leave any loose obkects in the
cabin which can cause any damage during
tipping over the cabin.
1. Remove side panels engine hood;
2. Take the lock pin with retainer out of his locking
position underneath the can. And place the lock pin
on the left platform, near the roatating point of the
cabin;
3. Open the engine hood;
IMPORTANT: Keep a clearence of 2 meter (80 inch)
front of the vehicle.
4. Close the knob on the handpump (CW);
5. Place pump lever in the pump and pump up the
cab. While pumping up the cab suspension lock
will be automatically opened for tipping over.
6. After tipping over the cab put in the lock pin with
reatiner immediatly.
m
DANGER: When the locking pin is not in
position, nobody is allowed under the
cab.
FIG. 3: Mark and disconnect air line to height control
valve.
m
WARNING: Remove all air pressure from
air system before disconnecting any air
hoses. Pressurized air can cause serious
personal injury.
Loosen and remove the three bolts (1) holding the
suspension to the chassis.
FIG. 2
q000180s
FIG. 3
q000181s
1
1