Service Manual

Table Of Contents

Air Tank and Pressure Control Check Valve

8-6 627333-A

AIR TANKS

NOTE: All orientation directions are in relation to the

driver’s position.

FIG. 1: Tanks (1) are mounted underneath the engine

(2). The wet tank collects condensation that can be

released by operating drain valve (3) on bottom of tank.

Air Tank Removal

NOTE: For example we use the wet tank.

FIG. 2: Mark and disconnect signal air hose (1) from

wet tank (2) to air governor.

Disconnect supply hose (3) from air dryer.

Disconnect output hose (4) to dry tank (5).

WARNING: Remove all air pressure from

tanks before disconnecting any air

hoses. Pressurized air can cause serious

personal injury.

FIG. 3: Remove nut holding hose support and remove

support.

Remove four nuts (1) that hold clamp and tank

assembly to frame brackets and remove tank

assembly.

Loosen tank clamps (2) and remove clamps from tank.

FIG. 1

q000175s

FIG. 2

q000176s

FIG. 3

q000177s