Service Manual

Section 7
Special Tools
Page 47
Figure 7.3
Figure 7.4
PULL BEARING
PULL BEARING
How to Make a Yoke Bar
1.
Measure dimensions A and B of the yoke you are
servicing. Figure 7.1.
2. Calculate dimensions C and D of the yoke bar by
adding 0.125-0.250-inch to dimensions A and B
of the yoke. Figure 7.2.
WARNING
Wear safe clothing and eye protection when you
use welding equipment. Welding equipment can
burn you and cause serious personal injury.
Follow the operating instructions and safety pro-
cedures recommended by the welding equipment
manufacturer.
3. To make the box section, cut and weld 1.0-inch x
2.0-inch mild steel square stock according to
dimensions
C and D. Figure 7.2.
4. Cut a 4.0-foot x 1.25-inch piece of mild steel
round stock to make the yoke bar handle. Center
weld this piece to the box section.
Figur
e 7.2.
•
To increase yoke bar rigidity: Weld two angle
pieces onto the handle. Figur
e 7.2.
!
Figure 7.1
Figure 7.2