Service Manual

627333-A 4-3
Brakes
Brake Operation
The two brake pads slide on the guide bolts in the
housing. When the brake is actuated, the cup springs
move the piston, adjusting screw thrust bolts and inner
brake pad contacts the brake disc. When the inner
brake pad contacts the brake disc, the housing shifts
onto the guide bolts and the outer brake pad pressed
against the brake disc also.
The brake is released by hydraulic pressure. When the
brake is released, the piston compresses the cup
springs, pulling the inner brake pad away from the
brake disc.
Brake lining and brake wear reduces braking force. The
brake must be adjusted to maintain braking force.
When replacing parts. Only use factory original parts
and part sets. Parts must be ordered through your
AGCO dealer. Any damage to parts not described in
this manual must be repaired or replaced using original
parts.
m
WARNING: Park the vehicle on the level
surface. Block the wheels to prevent the
vehicle from moving. Support the vehicle
with safety stands. Do not work under a
vehicle supported only by jacks. Jacks
can slip and fall over. Serious personal
injury and damage to components can
result.
FIG. 2:
m
WARNING: When the parking brake is
released, the vehicle does not have any
brake function. You must block the
wheels to prevent the vehicle from
moving. Serious personal injury or death
and damage to components can result.
FIG. 2
Q000059S