Service Manual

KENR6054 37
Disassembly and Assembly S ec tio n
33. Repeat Steps 31 and 32 for the remaining bearing
cages.
34. Install tube assembly (29) and bolt (28).
g01281835
Illustration 142
35. Attach Tooling (A) and a suitable lifting device
to the shaft assembly. Install Tooling (K). Apply
a slight lifting tension on the shaft assembly.
Use Tooling (K) in order to che ck the end p lay
of the shaft assembly. The end play should be
between 0.050 mm (0.0020 inch) and 0.100 mm
(0.0039 inch). Add or remove shims as shims are
required.
Note: It is important to rotate the shaft during the end
play adjustment in order to seat the bearings properly.
g01269221
Illustration 143
36. Install bearing cones (25) onto gear (24).
g01269183
Illustration 144
37. Use two people in order to install gear (24). The
weight of gear (24) is approximately 32 kg (70 lb).
Install ring (23).
g01269176
Illustration 145
38. Use two people in order to install gear (22). The
weight of gear (22) is approximately 23 kg (50 lb).
Install retainer (21) and bolt (20).
g01269118
Illustration 146
39. Lower temperature of bearing cup (19). Install
bearing cup (19). Install lip seal (17) and O-ring
seals (18) after adjusting the end play of the shaft
assembly.