Service Manual

6 KENR6054
Disassembly and Assembly Section
g01209507
Illustration 7
6. Remove spool assembly (11).
g01209518
Illustration 8
Personal injury can result from being struck by
parts propelled by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use all
recommended tooling to release the spring force.
7. R emo ve slug (16).
8. Use Tooling (A) in order to remove retaining ring
(15). Re move r et ain e r (14), spring (13), and ball
(12).
i02536679
Relief Valve (Transmission
Main) - A ssemble
SMCS Code: 5069-016-T3
Assembly Procedure
Ta b l e 2
Required Tools
Tool
Part
Number Part Description Q ty
A
1P-1853
Retaining Ring Pliers 1
Note: Cleanliness is an important factor. Before
assembly, thoroughly clean all parts in cleaning
fluid. Allow the parts to air dry. Do not use wiping
cloths or rags to dry parts. Lint may be deposited
on the parts which may cause trouble. Inspect all
parts. If any parts are w orn or damaged, use new
parts for replacement. Dirt and other contaminants
can damage the precision component. Perform
assembly procedures on a clean work surface. Keep
components covered and protected at all times.
Note: Check the O-ring seals, the gaskets, and
the seals for wear or for damage. Replace the
components, if necessary.
NOTICE
Caremustbetakentoensurethatfluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, “Ca terp illa r
Dealer Service Tool Catalog” for tools and supplies
suitable to collect and contain flu ids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.