Service Manual

Testing and Adjusting
3-26 627333-A
Test Procedure
FIG. 7: Pressure tap location for lubrication test.
Pressure gauges are used in the following test
procedure.
1. Attach a coupler to the transmission lubrication
pressure tap (1). If necessary, connect the
pressure hose. Install a pressure gauge 400 kPa
(58 psi) to the fitting.
2. Start the engine and warm the oil up to 60°C
(140°F).
3. Run the engine at LOW idle rpm with the
transmission control lever in the neutral position.
The pressure on the gauge must be a minimum of
4 kPa (0.5 psi).
4. Run the engine at HIGH idle rpm with the
transmission control lever in the neutral position.
The pressure on the gauge must be 179 ± 27 kPa
(26 ± 4 psi).
5. When the test is complete, stop the engine and
remove the test equipment.
FIG. 7
Q000049S
1