Service Manual

Transmission and Solenoids
3-6 627333-A
FIG. 5: Reinstall the drain plug (1) (spanner 1½”) once
all oil has been drained from the transmission.
FIG. 6: Apply a light coating of oil to the o-ring on the
transmission filter. This will aid to create a tight seal.
Fill the transmissoin filter with AGCO 821XL (J20C) or
equivalents.
Install the transmission filter (1) by hand. When the filer
seal contacts the filter base, tighten the filter element by
an additional turn of 270 degrees. Rotation marks are
spaced at 90-degrees intervals. Use these rotation
marks as a guide for proper tightening.
FIG. 7: Refill the transmission with AGCO 821XL
(J20C) or equivalents through the transmission fill tube
(1). Check the level of oil with the dip stick (2), with a
running engine
. The transmission will hold approximately 56,7 L (15
gal).
IMPORTANT: Do not overfill the transmission.
Overheating of the transmission will occur,
resulting in possible damage to the
transmission.
Recalibrate the transmission and check for the proper
oil level.
FIG. 5
1
Q000028S
FIG. 6
1
Q000029S
FIG. 7
1
Q000030S
2