Service Manual

627333-A 3-5
Transmission and Solenoids
TRANSMISSION OIL CHANGE
PROCEDURE
Start the machine and run it until the transmission oil
temperature warms. This is necessary to allow the oil to
flow freely during the draining procedure.
Place the machine on a hard, level surface and set the
parking brake. Remove the key and block the wheels.
FIG. 2: Remove the drain plug (1) (spanner 1½”) at the
underside of the transmission and drain the 56,7 L (15
Gall) of transmission fluid into an appropriate container.
IMPORTANT: It is extremely important to work in a
clean environment when working with
hydraulic systems.
NOTE: There are multiple drain plugs located on the
transmission. Only one plug needs to be
removed to drain the transmission oil.
NOTE: Be prepared to collect and contain all fluids in
an approved container. Transmission capacity
56,7 L (15 Gall).
FIG. 3: The transmission filter (1) is located to the front
and to the right of the transmission. Loosen and
remove the transmission filter.
Drain the filter into an appropriate container.
FIG. 4: The screen filter (1) is located at the left.
Loosen the cover of the filter housing. Clean the filter
with pressurized air.
m
WARNING: Wear safety goggles when
work with pressurized air. Small part with
a blowing away can come in your eyes.
Serious injury can result.
FIG. 2
1
Q000028S
FIG. 3
1
Q000029S
FIG. 4
Q000028S
1