User Manual

213
FAULTS AND REMEDIAL ACTIONS
E-box hardware fault.
Replace corresponding E-box (at workshop).
E-box basic programming invalid
(reprogramming, workshop task).
No longer functioning.
Suspension remains in the last position selected.
Partial failure of the electronic monitoring system.
Use the emergency mode only to move the tractor out of potential danger or to drive
to the workshop.
Specified/actual transmission slip limit exceeded. This fault may occasionally occur
under extreme conditions (e.g. at very low gear oil temperature) even if transmission
is mechanically sound. If the problem persists in normal operating conditions, contact
the workshop immediately.
Hydraulic tank empty.
Valves, front power lift and rear EPC are locked.
Refill hydraulic oil or switch the valve to floating position manually, so that oil can flow
back out of the external cylinder (see also OPERATION Section 17.4).
Switch ignition OFF and ON (Reset).
Valve remains incorrectly positioned or goes into neutral.
Display accompanied by a continuous beep and warning light.
Steering pump or control pump failed. Reduce vehicle speed. Contact the workshop
immediately and have the fault corrected.