User Manual

[НАЗВАНИЕ ДОКУМЕНТА]
МИХАИЛ ДОБРЫДЕНЬ
FAULTS AND REMEDIAL ACTIONS
Spool valves (valve 4)
Fault code
Cause
Effect and remedy
A.1.40
Valve not registered on the
CAN bus.
Valve actuation not possible.
A.1.4F
CAN-BUS error, valves.
Valves locked.
A.1.41
Electronics in valve faulty.
Valve goes into neutral position.
A.1.42
Voltage in the valve less than
8 Volt.
Valve goes into neutral position.
A.1.43
Voltage in excess of 18 V.
Valve goes into neutral position.
A.1.44
Valve actuator falls short.
Valve goes into neutral position.
A.1.4A
Valve actuator goes too far.
Valve goes into neutral position.
A.1.4B
Floating position not reached.
Valve goes into neutral position.
A.1.4C
Manual actuation.
A.1.45
High overvoltage over 45 V.
Valve goes into neutral position.
A.1.46
End stage error (end stage for
pilot control solenoid).
Valve goes into neutral position.
A.1.47
Position pickup sensor error.
Valve goes into neutral position.
A.1.48
Valve actuator does not return
to neutral position.
Valve remains set.
A.1.49
Valve actuator not in neutral po-
sition when switched on.
Valve remains set.
Electric valves (E-box)
Fault code
Cause
Effect and remedy
A.1.A0
EEPROM error.
Loss of enhanced features when opera-
ting valves.
A.1.A1
A.1.A2
More valves connected than
are registered through end-of-
line programming. Undertake
programming.
Not all valves can be operated.
A.1.FO
Valve control for the switching
of the pilot control of all electri-
cal valves with front power lift
faulty.
All valves go into neutral position.
A.1.F1
Valve control for the heating of
all electrical valves with front
power lift faulty.
Reduced operation in cold conditions.
A.1.F2
Valve control for switching the
pilot control of all spool valves
with front power lift faulty.
Call workshop.
A.1.F3
Valve control for switching the
pilot control of all spool valves
with front power lift has inter-
rupted supply line.
Call workshop.