User Manual

214
FAULTS AND REMEDIAL ACTIONS
Hydraulic oil temperature too low.
Operate until the oil has warmed up and unlock the valve again.
After manual operation, the valves cannot only be operated again with the crossgate
lever or toggle switches after a Reset (engine OFF then ON).
Level of coolant too low.
Top up with coolant.
CAN bus communication restricted.
Impossible to control the mounted implement via Vario Terminal.
Check operating manual of the implement manufacturer or contact their service.
Relieve right or left draft sensing pin of load.
In accelerator pedal mode, the driving direction must be re-entered if the tractor is in
active stationary mode.
Variotronic Ti functions cannot be played back.
Valves cannot be actuated.