Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
81
OPERATION
Changing the activation speed of the
stabilising system
Operation_Pic_number:1
● Press key (F5). The following sub-menu ap-
pears.
Operation_Pic_number:1
● With rotary switch (P2), set indicator (A) to the
desired switch-on speed
Setting range 0 - 30 km/h.
Fig.170
Fig.171
18.5 Electronic slip control
Text-module
(optional).
Operation_Pic_number:1
● Turn electronic slip control on and off with the
key (F2).
When the slip control is inactive, symbol (A) is
shown.
Setting slip control sensitivity
Operation_Pic_number:1
● Set the implement to the desired type of con-
trol (position / traction mix control).
● Press key (F3). The following submenu appe-
ars.
CAUTION:
The tractor is equipped with a radar
sensor. Do not look directly into the
radar sensor. Microwave radiation!
Fig.172
Fig.173