Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
39
OPERATION
7.4 Driving mode selector
Operation_Pic_number:1
The currently selected mode is indicated by a
spot (A). The selected mode is indicated by a
flashing spot.
Text-module
● The driver can use button (M) to switch from
range I to range II.
NOTE:
The last range selected is always set, even af-
ter turning the ignition on or off.
Text-module
RANGE I (field)
For heavy field use at a speed of:
0.02 - 32 km/h forward.
0.02 - 20 km/h in reverse.
Text-module
RANGE II (road)
For fast transport at speeds of:
0.02 - 50 km/h forward.
0.02 - 38 km/h in reverse.
Text-module
WARNING:
When selecting driving mode,
tractive power is interrupted. Do not
use on slopes (uphill or downhill).
Fig.52
Switching when tractor stationary
● Select Neutral position or
● operate clutch pedal.
● Select the desired mode.
Text-module
Selecting driving mode I or II while
travelling
Driving mode selection is not possible if:
● Neutral position is engaged.
● Transmission oil temperature below 10°C.
● Engine brake actuated.
Text-module
Switching from operating range II to I
when travelling
Driving mode selection is not possible if:
● Ground speed over 20 km/h.
● Neutral position is engaged.
● Engine speed over 2300 rpm.
● Transmission oil temperature below 10°C.
● Engine brake actuated.
NOTE:
In unfavourable conditions, e.g. cold weather,
selecting a driving mode may simply cause
the neutral position to be selected. Interrup-
tion of tractive power, repeat driving mode
selection with button (M/ OPERATION
Fig. 52).
Cruise control and Quick Reverse function
deactivated.