Operating Manual

37
OPERATION
6.4 Tow-starting
6.5 Stopping the engine
● Turn ignition key to position 0.
Text-module
NOTE:
After operating at full load, do not stop the en-
gine immediately but allow it to cool down for
about 2 minutes at about 1000 rpm.
6.6 Stopping and immobilising
the tractor
Hazard warning triangle
Operation_Pic_number:1
The hazard warning triangle (A) is attached
behind the driver seat (hazard warning triangle
not included as standard).
We would recommend ordering the warning
triangle from:
GEKA GmbH Germany 73054 Eislingen / Fils
Schloßstraße 97
Tel. [phone]
Fax [phone]
WARNING:
Tow-starting is not possible!
WARNING:
Before leaving the tractor, apply the
hand brake, stop the engine, lower
hydraulic implements to the ground
and remove the ignition key. Make
sure the tractor is secured to
prevent it rolling. On slopes, chock
the wheels. If the tractor is left on a
public road, switch on the hazard
warning lights and place the hazard
warning triangle.
Fig.47
7. Vario transmission
7.1 Joystick
Operation_Pic_number:1
Text-module
A = Setting forward transmission ratio.
B = Setting reverse transmission ratio.
C = Change of direction of travel (forward/re-
verse using the joystick).
D = Tempomat cruise control ON.
7.2 Neutral position
If the engine is started or hand brake is applied,
the transmission shifts to Neutral position.
Operation_Pic_number:1
Text-module
● The transmission is neutralised or activated
with the neutral button (N).
WARNING:
Before leaving the tractor, make sure
the transmission is set in neutral
and engage parking brake.
Indicators with Neutral position selected.
1.LED (N1) lights up.
2.Travel direction indicator lamps (C) flash.
3.Clock and operating hours (D) indicators on
the multiple display.
Fig.48
Fig.49