Operating Manual

35
OPERATION
Tractor in driving mode
If the tractor moves off immediately after it is
started, the following picture appears.
Operation_Pic_number:1
The selected settings (see OPERATION
Section 28.1) can not be activated.
Key F5 = Main menu appears.
The main menu appears automatically after
about 10 seconds.
Text-module
or
The selected settings (see OPERATION
Section 28.1) should be activated.
Bring tractor to a standstill and press the neutral
button, further operation (see OPERATION
Fig. 43).
Fig.44
6.2 Starting the engine
IMPORTANT:
Do not start or operate the tractor without a
battery. This could destroy the alternator.
Pay attention to warnings and fault mes-
sages. If necessary, switch off the engine im-
mediately.
● Apply the hand brake.
● Depress clutch pedal (starting inhibit is deac-
tivated).
● Switch off PTOs and other drives.
● Electrical operating Switch off all consumers
if possible.
Operation_Pic_number:1
● Turn ignition key to position I, following sym-
bols are illuminated:
● The LED neutral switch on the multi-function
joystick.
● Turn ignition key to II and once the engine
has started, move it back to I.
● Battery charge indicator lamps must go out.
NOTE:
If at very low temperatures the engine does
not start within about 20 seconds, abort the
starting procedure, allow the starter to cool
down and wait for about 1 minute before try-
ing again.
Switch off ignition before attempting to start
again.
Allow starter to cool down. Do not operate the
starter while the engine is still turning. In the
event of repeatedly unsuccessful starting at-
tempts, refer to 'FAULTS AND REMEDIAL AC-
TION'.
To avoid unnecessary white smoke, operate
the tractor at 1,000 rpm maximum for up to
5 minutes (depending on temperature). (Can
be driven with no load).
Charge indicator lamps.
Driving direction indicators.
Wait until preheat indicator flashes.
Steady light indicates preheating time.
Fig.45