Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
33
OPERATION
4. Rearwiew mirror
Pull-out rearview mirror
Operation_Pic_number:1
● Adjust to tractor and/or trailer width using
screw (arrowed).
CAUTION:
Before driving the tractor and
starting work, adjust the mirror to
guarantee a clear view of the road
and of the working area to the rear.
Fig.39
5. Start-up
5.1 Daily check
Text-module
Tractor must be in proper working condition.
Operation_Pic_number:1
● Check fuel level. If necessary, top up through
filler neck (A).
Top up with fuel after the day's operation to avoid
build-up of condensation. If it has run dry, bleed
the system.
● Check engine oil level (see also CARE AND
MAINTENANCE Section 3.4).
● Check transmission oil level (see also CARE
AND MAINTENANCE Section 10.2).
● Drain the water from compressed air bottle
(see also OPERATION Section 22.1).
Fig.40