Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
30
OPERATION
Pin - attribution LBS-ISO implement
socket rear and front
Operation_Pic_number:1
A = LBS-ISO socket for the mounted implement.
B = LBS-ISO connector for the mounted
implement.
Pin 1 = Earth 60A.
Pin 2 = Earth 25A.
Pin 3 = 60A power supply.
Pin 4 = 25A power supply for implement electro-
nics.
Pin 5 = Control signal for switching the end sy-
stem, bridged with pin 4 in the connector.
Pin 6 = CAN-EN.
Pin 7 = CAN GND.
Pin 8 = CAN High.
Pin 9 = CAN Low.
Fig.31
ABS socket (A)
Operation_Pic_number:1
1 = + UB 30
2 = + UB 15
3 = Earth electronics
4 = Earth tractor body
5 = Indicator lamp
IMPORTANT:
When turning the ignition ON or OFF, the in-
dicator lamp (B) in the instrument panel must
light up briefly for monitoring purposes.
Operation_Pic_number:1
Socket (A) at front (with front power lift only).
Operation_Pic_number:1
LBS-ISO socket (A) front (optional).
Fig.32
Fig.33
Fig.34