Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
27
OPERATION
Selection of the jump menu items
The jump menu items that can be selected, de-
pend on the tractor equipment, e.g. if no front
power lift is fitted, this jump menu item is not
shown in the selection list.
Front power lift
Rear power lift
Rear power lift settings
Rear power lift settings, slip control
Overview of electrical valves
Electrical valves 1-4
Cruise control, load limit control
Quick reverse
Engine speed min. - max.
Fuel consumption indicator
On-board computer overview
On-board computer 1- 4
Load implement settings
Only possible if Teach In and the
automatic modes for the power lift and
PTO are not active.
Save implement settings
Only possible if Teach In and the
automatic modes for the power lift and
PTO are not active.
Implement control
Only possible if implement being
installed.
Teach-in
Camera
Camera image mirrored
Terminal settings
Implement control diagnostics
Tractor diagnostics 1
Tractor diagnostics 2
TMS settings
Page with speeds