Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
261
TECHNICAL DATA
Brake pedal free play max. 110 mm.
X X X X Check active parking function. After the test drive. Stop the tractor using the joystick. Active symbol appears in
the multi-display. After the tractor has been stationary for about 5 seconds, open
the emergency operation cover.
Engage driving mode II, turn the transmission adjuster about 15 degrees to the
left.
The tractor should not move forward.
For summary of services, see Operating Manual
(inside back cover) and also the workshop data
card.
1) Max. values Whichever comes first. In difficult
operating conditions, more frequent maintenance
is recommended. Always have the main service
carried out before long periods of non-use.
2) If the fuel contains more than 0.5% sulphur, the
oil replacement intervals should be halved.
4) For registered trade names, refer to the current
list of Fluids and Lubricants, which is available
(as customer information) from every Fendt-ap-
proved workshop.
3) VISCOSITY OF ENGINE OILS
No.
Services
regularly 1)
daily
Job Schedule
See also Operating Manual
Care and Maintenance
General notes and technical data, types of fluid and oil
Correct levels are determined by dipstick check or from the overflow at the
inspection hole.
Observe all accident prevention regulations and comply with directives for
handling and disposing of fluid and lubricants.
1.
50
2.
250
3.
500
4.
750
5.
1000
annu
al or
every
500
every 2
years
or
2000
operating hours
Monograde oils Multigrade oils