Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
26
OPERATION
2.14 Camera function
Text-module
(optional).
Operation_Pic_number:1
● Press the F1 or F2 key.
Following sub-menu for terminal settings appe-
ars.
Operation_Pic_number:1
Text-module
Press the ESC key twice.
● Toggles between main, implement and ca-
mera menus.
Setting brightness and contrast.
● Brightness can be set with the rotary control
(P1).
● Contrast can be set with the rotary control
(P2).
Fig.20
Fig.21
2.15 Quick Jump
Text-module
This function allows a preset menu page to be
selected directly from the first menu level.
Turning the rotary control (P1 - P3) slightly, se-
lects the preset menu page.
Press ESC key
● Display returns to first main menu.
Selecting menu pages
Operation_Pic_number:1
● Press F3 key.
Following sub-menu for terminal settings appe-
ars.
Operation_Pic_number:1
● Choose the desired menu page with the F2 -
F4 keys.
Press key repeatedly until the desired menu
page appears.
● Switch function on and off with the F5 key.
● LED lights up green - function is on.
Text-module
Fig.22
Fig.23