Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
258
TECHNICAL DATA
X Clean the fan shroud. Clean with high-pressure cleaner - also refer to Fendt Customer Service memo
12/02.
as requi-
red
Check, and if necessary clean the cooling fins
on engine, hydraulic system, charge air, trans-
mission and air conditioning system.
Blow out with compressed air or with a dust extractor.
X X X X as requi-
red
Air filter maintenance. Maintenance required only if a fault (symbol) is indicated on the multiple display.
Clean with compressed air at 5 bar max., then check for damage.
X Replace air filter main cartridge.
X X X X Check air filter suction line for leaks, check
maintenance switch and indication on multiple
display 1).
There should be no cracks on the intake hoses.
X 1000 Clean the heater and roof fan filters. Repeat more frequently if fan output begins to fall.
X X X Clean the recirculating air filter of heater and
roof fan.
Repeat more frequently if fan output begins to fall.
2 Transmission
X X X X Check fluid level in reservoir for brake and
clutch actuation 1).
Top up if necessary. For Min and Max marks, see reservoir.
X Fluid for brake and clutch operation. Filling capacity: 0.8 litres
Type: Hydraulic oil Pentosin CHF 11 S (X 902.011.622).
X Check oil level in transmission and differential. Quantity of oil between MIN and MAX markings: approx. 3.0 l
Max. oil quantity: 85.0 litres
X Change the transmission oil and replace trans-
mission oil suction filter.
Oil quantity: Vario 916-920 refill 65.0 l
Oil quantity: Vario 924-930 refill 67.0 l
Oil grade: Fendt Extra Trans 10W-40 or STOU SAE 10W-40 or
15W-40 acc. to API GL4 4).
X X 1000
on in-
dica-
tor
Replace transmission oil pressure filter. If the 'Pressure filter dirty' symbol appears on the multiple display, replace filter as
soon as possible.
X X Front PTO: replace transmission oil. Oil quantity: 4.2 litres
Oil grade: Fendt Super Trans 85W-90, 80W or Hypoid transmission
oil acc. to API-GL5. SAE 85W-90 or SAE 80W-90 or SAE
90. Not STOU or other any universal oil.
No.
Services
regularly 1)
daily
Job Schedule
See also Operating Manual
Care and Maintenance
General notes and technical data, types of fluid and oil
Correct levels are determined by dipstick check or from the overflow at the
inspection hole.
Observe all accident prevention regulations and comply with directives for
handling and disposing of fluid and lubricants.
1.
50
2.
250
3.
500
4.
750
5.
1000
annu
al or
every
500
every 2
years
or
2000
operating hours