Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
232
FAULTS AND REMEDIAL ACTIONS
Operating console
Text-module
Transmission
Fault code Cause Effect and remedy
3.1.01
3.1.02
3.1.03
3.1.04 Programming error. Call workshop.
3.1.05
3.1.06
Fault code Cause Effect and remedy
4.1.01 Joystick acceleration switch
I-IV faulty.
Auxiliary operation.
4.1.04 Clutch pedal potentiometer
faulty.
No monitoring of transmission ratios.
4.1.05 Pressure sensor II defective. Reduced comfort.
4.1.06 Accelerator rotary control faulty. Load limit control not functioning.
4.1.07 High-pressure sensor faulty. Peak loads in the transmission are no
longer monitored.
4.1.08 Operating range I/II analogue
device (function angle device)
faulty.
Operating range switching I/II not opera-
tional.
4.1.20 Accelerator cancellation rotary
control incorrectly calibrated or
not calibrated.
Accelerator mode not working.
4.1.21 Reverse mode switch is defec-
tive.
Reverse mode operation and accelerator
mode no longer possible.
4.1.22 Accelerator cancellation rotary
control faulty.
Restriction in operation of accelerator
mode.
4.1.23 Joystick signal Tempomat on
faulty.
Auxiliary operation.
4.1.24 Hand brake switch faulty. Hand brake automatic mode not working.
4.1.25 Joystick F-R quick reverse si-
gnal faulty.
Auxiliary operation.
4.1.26 Joystick signal accelerator
mode faulty.
Accelerator mode not working.
4.1.27 Armrest signal rapid reversal
(F/R rocker) faulty.
Rapid reverse not working.
4.1.28 Track width adjustment faulty. Auxiliary operation.
4.1.29 Joystick park position signal
faulty.
Auxiliary operation.
4.1.2A Bevel pinion rpm sensor direc-
tion signal faulty.
Auxiliary operation.
4.1.2B Driving mode I/II selection but-
ton faulty.
Tractor remains in current dricing mode.
No further selection until ignition ON/
OFF.
4.1.2C 'Neutral selection' button faulty. Auxiliary operation.
4.1.2D Quick Reverse button (steering
column) faulty.
Quick Reverse only available with the
joystick.
4.1.2E Joystick key 'v+' faulty. Auxiliary operation.
4.1.2F Joystick v- faulty. Auxiliary operation.
4.1.31 Direction signal speed sensor
for hydrostatic unit faulty.
Auxiliary operation.
4.1.32 Joystick activating button faulty. Auxiliary operation.
4.1.42 Speed sensor hydrostatic unit
faulty.
Auxiliary operation.