Operating Manual

230
FAULTS AND REMEDIAL ACTIONS
Text-module
Electronic engine control
1.1.BO Communication driver initialisa-
tion error; limited CAN bus
communication.
EOL programming.
1.1.EO Calibrated values from manual
throttle rotary control incorrect.
Manual throttle rotary control calibration.
Fault code Cause Effect and remedy
1.2.13 Battery voltage too low. Reduced engine operation.
1.2.17 Engine overspeed. After the overspeed is left, normal opera-
tion.
1.2.18 Start of injection incorrectly set. Reduced end speed, reduced engine
power. Check fuel system.
1.2.1A Needle movement sensor in-
correct values.
Engine control changed.
1.2.9B Solenoid valve has incorrect
values.
Reduced end speed, reduced engine
power.
1.2.1E Injection pump. Reduced speed, reduced engine power.
1.2.1F Engine control unit or connec-
tion interrupted.
Auxiliary operation.
1.2.21 FENDT control module to
transmission bus connection in-
terrupted.
Optimum engine control not possible.
1.2.23 FENDT control module to EDC
control module connection in-
terrupted.
Loss of enhanced features, only foot
throttle available.
1.2.25 Main relay does not open. Battery is discharged.
1.2.2A FENDT control module to EDC
control module connection in-
terrupted.
Normal operation - fault indication.
1.2.2B FENDT control module to EDC
control module connection in-
terrupted.
No control of engine brake.
1.2.2C FENDT control unit connection
to engine brake interrupted.
No control of engine brake.
1.2.2D FENDT control module to EDC
control module connection in-
terrupted.
Loss of enhanced features, only foot
throttle available.
1.2.2 E FENDT control module to EDC
control module connection in-
terrupted.
Optimum engine control not possible.
1.2.38 Control unit. Reduced speed, reduced engine power.
1.2.42 Injection pump. Reduction in power.
1.2.46 Control unit. Loss of enhanced features, only foot
throttle available.
1.2.81 Pedal position sensor signal
wrong.
Normal operation - fault indication.
1.2.82 Injection pump, supply of flow. Engine cuts out, engine does not start.
1.2.84 Engine speed sensor, control
module.
Reduced speed, reduced engine power.
1.2.85 Boost pressure sensing device. Reduced engine power.
1.2.87 Temperature sensor (coolant),
control module.
Reduced engine power.
1.2.89 Injection pump. Engine does not start.
1.2.91 rpm sensor. Reduced speed, reduced engine power.
1.2.92 Injection pump, engine control
module.
Reduced end speed, reduced engine
power.
Fault code Cause Effect and remedy