Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
227
FAULTS AND REMEDIAL ACTIONS
3. Warning and information messages for imple-
ment settings
Operation_Pic_number:1
Warning and information messages (A) are shown on the Vario terminal.
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
1. Engine speed is less than 400 rpm
Process is not started.
Increase engine speed.
2. Transmission not in neutral
Process is not started.
Put transmission into neutral.
3. FRONT power lift/PTO automatic mode active on the
operating console
Process is not started.
End FRONT power lift/PTO automatic function on the control console.
4. REAR power lift/PTO automatic mode active on the
operating console
Process is not started.
Switch off REAR power lift/PTO automatic mode on the operating console.
5. FRONT and REAR power lift/PTO automatic mode active
on the operating console
Process is not started.
Switch off FRONT and REAR power lift/PTO automatic mode on the operating
console.
6. Variotronic Ti information message active
Fig.4