Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
214
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
19. Hydraulic valves (crossgate lever)
Valves cannot be actuated.
20. Hydraulic valves (oil temperature)
Hydraulic oil temperature too low.
Operate until the oil has warmed up and unlock the valve again.
21. Hydraulic valves (manual operation)
After manual operation, the valves cannot only be operated again with the crossgate
lever or toggle switches after a Reset (engine OFF then ON).
22. Engine coolant (level)
Level of coolant too low.
Top up with coolant.
23. Initialisation error on communication driver
CAN bus communication restricted.
24. Fault of mounted implement in implement control mode
Impossible to control the mounted implement via Vario Terminal.
Check operating manual of the implement manufacturer or contact their service.
25. Right or left draft sensing pin overloaded
Relieve right or left draft sensing pin of load.
26. Seat switch defective
In accelerator pedal mode, the driving direction must be re-entered if the tractor is in
active stationary mode.
Variotronic Ti functions cannot be played back.