Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
212
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
3. Front or rear PTO
Try engaging with another button (5 seconds).
4. EPC rear lifting gear
Move Quick Lift switch fully or turn ignition off and on again.
5. Front power lift
Move Quick Lift switch fully or turn ignition off and on again.
6. Multifunction control lever
Rear/front automatic mode on/off switch faulty.
Automatic mode stop button faulty.
7. Transmission control
Call up fault code and refer to the code table for what measures to take.
8. Sensors
No pressure, speed or volume monitoring.
It is essential to determine the cause of the fault immediately using the code table
(see FAULTS AND REMEDIAL ACTIONS Section 5).
9. Electronic system
Display accompanied by a continuous beep and warning light.
Electronic connections between components are faulty or cut. Other fault codes may
occur.
10. Indicator lamps
In the event of failure of the forward/reverse indicator lamps, the backup indicators
can be activated (see also OPERATION Section 26.5).